Initial Setup Of The Yealink Devices (Vc110 & Vc120) - Yealink VC110 Quick Manual

Initial Setup of the Yealink Devices (VC110 & VC120)
Your device will walk you through a guided setup using your remote.
Configure your network information for the Yealink device (see image below)
Using your remote, do the following steps:
1. Menu->Advanced (Default Admin Password: 0000)->LAN Configuration
2. Turn off [DHCP] .
3. Enter the ​ P rivate IP address, subnet mask, gateway, DNS information​ (provided by
your network admin) in the corresponding fields.
4. Press Save to save the configuration, then if the screen prompts {Reboot now}. Press
[OK] to reboot the endpoint.
Contact Us
support@easymeeting.net
helpdesk.easymeeting.net