Advertisement
FIGURE 1
FIGURE 2
Upper Holes / Shorter Bolts
FIGURE 3
1
2
1 - Bolt
2 - Loop
FIGURE 4
RIGHT
1
2
FRONT
1 - Spreader Arms
2 - Crossbar
6
Assemble Table Bed and A-Frame Base
Lower Hole / Longer Bolt
FIGURE 3a
LOCKED
LEFT
REAR
FIGURE 4a
UNLOCKED
STEP 1
Assemble the Upper and Lower Portions
of the Table Bed
NOTE: Do not detach the Bed Frame Extension from the clips.
• Locate the Table Bed Assembly Hardware Kit (HK1006)
• Lay the Upper and Lower Portions of the Table Bed face down on
the floor (Figure 1).
• Gently lift the base of the pre-assembled Bed Frame Extension
while sliding the Lower Portion and Frame onto the Upper Portion.
Align the shaft of the frame into the plastic track of the Upper
Portion (Figure 2).
• Align the bolt holes of the upper part of the frame (triangle-shaped
area) to the bolt holes on the Upper Portion. Release the Bed Frame
Extension so that it rests on top of the bolt holes (Figure 3).
• Reaching underneath, insert one of the shorter bolts through one
of the holes in the Upper Portion and hold in place. Slide one of the
Bed Frame Extension loops over the bolt and handtighten with a
nut (Figures 3 and 3a). Repeat with other side.
• Reaching underneath, insert the longest bolt into the lower hole
(Figure 2) and hand-tighten with a nut.
• To fully tighten all three nuts to the bolts, insert the Allen Wrench
into the bolt heads and tighten the nuts using a 10/13 mm Open-
Ended Wrench.
Assemble the A-Frame Base
• On a level surface, position the A-Frame so that it is standing upright
and the Stability Feet are on the ground.
• Gently push down on the Spreader Arms to ensure they are fully open
and in the "locked" position (Figure 4).
• Look for temporary circular assembly assistance labels on the
A-Frame. RIGHT, LEFT, FRONT, and REAR indicate your position while
using the equipment, not facing it. These labels can be removed easily
upon completion of assembly.
Hide quick links:
Advertisement
