Teeter 700ia Assembly Instructions Manual page 14

FIGURE 24
FIGURE 25
12
STEP 7
Attach Angle Tether and Head Pillow
The 700ia is shown here. Your actual model may vary.
Attach Angle Tether
• The tether will come pre-assembled to the A-Frame.
• Unfold the adjustable tether and clip it to the U-Bar on the
underside of the Table Bed (Figure 24).
• Slide the buckle to lengthen or shorten the strap depending on
your desired maximum angle of inversion.
SHORTEN
Attach Head Pillow
Attach the Head Pillow by securing the Velcro Straps through the
holes in the Table Bed (Figure 25). You may customize the position
depending on your preference.
LENGTHEN