Advertisement
FIGURE 10
FRONT
FIGURE 11
FIGURE 12
FIGURE 13
8
STEP 3
Assemble Table Bed to A-Frame
• Face the front of the A-Frame where the Crossbar is located (Figure 10).
• Grasp both Roller Hinges, right above the Cam Lock, and lift the
REAR
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates one
• Make sure that each Pivot Pin is seated at the base of the slot in the
FIGURE 12a
TOP VIEW
• Rotate the Table Bed into the use position (Figure 13). Ensure that
FIGURE 12b
INSIDE VIEW
The 700ia is shown here. Your actual model may vary.
Table Bed. Allow the top of the Table Bed to rotate toward the floor
so that the back of the Table Bed is now facing you and the top of the
Table Bed is in front of the Crossbar (Figure 11).
side at a time (Figure 12). The Self-Locking Hooks will open to allow the
Pivot Pin into the Hinge Plate slot, then automatically snap closed
over the Pivot Pin.
TIP: You may need to push outward on the Hinge Plate in order for
the second Pivot Pin to lock in place.
Hinge Plates and that the Self-Locking Hooks have closed over both
Pivot Pins (Figures 12a and 12b).
WARNING
!
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
could result in serious injury or death!
it rotates smoothly. See also Image A on Page 12 to ensure
correct assembly.
Hide quick links:
Advertisement
