Advertisement
FIGURE 17
FIGURE 18
FIGURE 19
FIGURE 20
10
STEP 5
Assemble Main Shaft to Table Bed
The 700ia is shown here. Your actual model may vary.
• Facing the front of the A-Frame, hold the Main Shaft in your left hand
with the height markings facing up. Slide the end of the Main Shaft
into the Main Shaft Housing (Figure 17) located at the base of the
Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin
(Figure 18) to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner's Manual for more
information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar bumper on the
A-Frame (Figure 19).
IMPORTANT: The Crossbar prevents the Table Bed from rotating
forward when the user steps on the Ankle Comfort Dial. If the
Main Shaft does not rest on the Crossbar bumper as shown in
Figure 19, then the Table Bed has been assembled backwards
onto the A-Frame.
This MUST BE CORRECTED before use. See also Image B on Page 12
to ensure correct assembly.
• Test the inversion table by hand for smooth and steady rotation
(Figure 20) and ensure that all fasteners are secure.
Hide quick links:
Advertisement
