Table of Contents
Advertisement
FIGURE 3
1
2
1
Crossbar
2
Support Beam
Unpacking Instructions
Follow these important unpacking instructions to properly remove the parts from the box and
avoid damage to your new inversion table.
IMPORTANT: The Table Bed Assembly is heavy – be sure to complete this step with two people.
• Remove all cardboard and packing materials from the box.
• To disengage the Table Bed from the A-Frame, carefully LIFT the support beam high enough
to clear the Crossbar and Rubber Bumper on the A-Frame. Then, slide BACK and separate
the Table Bed Assembly from the A-Frame (Figure 3).
• Set the Table Bed Assembly to the side and continue unpacking.
• Be sure to remove protective plastic from all items prior to assembly.
TIP: Unpack materials and prepare to set up your Contour Power Inversion Table in its
permanent location. Keep in mind that you will require an electrical outlet to power your table.
Advertisement
Table of Contents
Need help?
Do you have a question about the Contour Power and is the answer not in the manual?
Questions and answers