Menu Controls - Honeywell GENT Operating Instructions Manual

Menu controls

Menu controls
Panel beeps
on button press
Fault
Panel Healthy
Power Fault
System Fault
Delay
[Control] [ Set Up
Test
Disablement
Menu On/Off
F1
Sound Alarms
The MENU ON/OFF button activates the function keys F1 to F4 for the
selection of menu prompts that appear above the function keys on the display.
At any level in a menu, single press of the MENU ON/OFF key aborts an
operation. However as an alternative the [Quit] option can be selected to exit
the function mode.
If the time taken between key presses exceeds fi ve minutes, then the control
panel will automatically remove the menu options from the display and give a
system status indications.
20
15:45
Vigilon Fire System
GENT 2015
Designed to EN54 Pt 2 & 4
] [ Info ] [ Test/Eng]
Previous Next
F2 F3 F4
Reset
Silence Alarms
The [Params] option is a Help function to
provide information to the user regarding the
type of input data required.
On
Most of the functions in the [Control], [Setup]
Flashing
and [TestEng] menu options are protected with
password entry. The password is programmed
during the commissioning of the system and is
passed on to the site person responsible for the
fi re alarm system.
Fire
Verify
Sounder
Fire Routing O/P
Active
Fault/Dis
Where a password code is not set up, there
Power
is an open entry to operate the controls under
Cancel Buzzer
[User Code]. Where this is true the instructions
for entering the access code, password (or PIN)
Verify
in the following instructions should be ignored.
An open access to controls
under User code is undesirable,
so it is recommended that a
customer password is setup.