Other Enable/Disable Options; How To View A Device Label - Honeywell GENT Operating Instructions Manual

Other enable/disable options

There are other options such
as Sounders, Command Build,
Group, and Communication that
are accessible for enablement and
disablement, for further advice
contact your servicing organisation,
see the Log book for contact details.

How to view a device label

This operation is not applicable for a Network Node.
NA
Each device in the system is given a location label at the time the system is
commissioned to identify its installation position. To view a device label you will need to
know the device address and the loop on which it resides, which can be found in the site
specifi c documentation held by the person responsible for the fi re alarm system.
a. Press the MENU ON/OFF button.
b. Press the F3 button to select [Info]. Ignore step c. if an external printer is not
fi tted or is switched off.
c. To display a device label press the F1 button to select [Display] or to print a device
label press the F2 button to select [Print]. Notice 'Display' or 'Print' appears on the
screen.
d. Press the F4 button to select <etc>.
e. Press the F2 button to select [Label]. Notice 'Label' appears on the display.
f. Press the F3 button to select [Device]. Notice 'Device' followed by a fl ashing cursor
appears on the display. Use the keypad to input a Device number or range (1-200).
g. Press the F2 button to select [Loop]. Notice 'Loop' followed by a fl ashing cursor
appears on the display.
h. Press the F2 button to select [Enter]. Notice the selected label information is either
displayed or printed.
Use the keypad to input a loop number (1 or 2).
Vigilon fire alarm system
29