Battery Replacement; Replacing Printer Paper - Honeywell GENT Operating Instructions Manual

Battery replacement

It is recommended where batteries are installed they are replaced at
4 Yearly intervals from the date the system is fi rst commissioned.
Any servicing work on the system must be carried out
by a suitably trained person, such as an engineer from
the servicing organisation.

Replacing printer paper

The printer paper roll is located on the inside of the inner door. A
vertical line on the paper indicates the end of paper.
VS-PROLL Replacement paper roll
a. Open the panel outer door using the key supplied and then open
inner door using the allen key/fl at ended screw driver dependent on
panel construction.
b. Remove the old paper roll from inside of the inner door assembly.
Where the paper roll holder is vertically above the mechanism then
do : d), e) and then c).
c. Fit the new paper roll to the holder.
d. Insert paper from the new paper roll into the printer mechanism.
e. Turn the paper feed wheel located on the outside of the inner door
downwards to feed paper thru the print mechanism and out.
f. Close the inner door and lock it.
g. Carry out a printer paper test, see panel controls section of this
manual.
h. Close the outer door and lock it.
Vigilon fire alarm system
Choose the paper roll feed appropriate for your panel
Door
Printer
mechanism
Door
Fold paper end thus
before attempting to
feed it through printer
Paper
roll
Printer
mechanism
Paper
roll
37