Automatic Detection Of Fire - Honeywell GENT Operating Instructions Manual

Automatic detection of FIRE

Automatic detection of FIRE
A fi re in your protected premises is automatically sensed at any
one of the fi re detection devices installed in the building, such as
a sensor or a fi re input from an interface. The control panel
actions the alarm sounders in the system and at the same time
gives the details of the fi re event. The event indication is repeated
at all repeat indicator panels in the system.
Panel
buzzer
The 'Zone indicators' are not applicable for Vigilon Network Node
1
Zones
Fault
1stFIRE:MCP:Zone 1
Power Fault
First Fire occurred at:
System Fault
Time: 15:43.10
Delay
Test
Disablement
14
15:45
Mon 16 March 2015
Previous Next
If configured this light indicates there is an active Fire routing
output to Alarm Receiving Centre to initiate Fire fighting action.
With the panel door open:

To cancel
buzzer
To silence
alarms
On Flashing
To reset
system
Fire
Verify
Sounder
Fire Routing O/P
Active
Fault/Dis
Power
Record
the event
You can stop the panel buzzer from
sounding.
Cancel buzzer
Press:
Display reads: 'Buzzer cancelled'
When the emergency is over the alarm
sounders can be silenced.
Silence alarms
Press:
Display reads: 'Alarms silenced'
To return the system to normal condition
clear any residual smoke or heat from
sensors and reset element or replace the
glass in any manual call point where the
glass was broken.
Ensure the fi re system is checked by
your servicing organisation if there
has been fi re damage in the protected
area.
Reset
Press:
Display reads 'System being Reset -
please wait....'
Make an entry in the log book of the
event for future reference.