Honeywell GENT Operating Instructions Manual page 8

Description of controls and indications
Indicators Description
Display The Display provides messages of the system status / events by means of 8 lines by 40 characters per line display.
Secret-until-lit fi re zone indicators. When the "Zones" text and number(s) are illuminated it indicates that a FIRE has
Zones 1
been detected in the indicated zone(s).
(red)
When illuminated it indicates that a supply to the panel is present.
Power
(green)
When illuminated it indicates that a FIRE has been detected in the protected premises.
Fire
(red)
When illuminated it indicates that the Verify button has been pressed and the alarm sounders in the system are
Verify
delayed from sounding.
(amber)
When illuminated it indicates that a FAULT has been detected in the fi re detection and alarm system.
Fault
(amber)
When illuminated it indicates that a fault has occurred with the system processor. It is important to investigate this
System Fault
fault because the fi re system may not be able to detect fi res.
(amber)
When illuminated it indicates that a part of the system has been disabled.
Disablement
(amber)
When illuminated it indicates the Output to the Fire Alarm Routing Equipment is active.
Active
(red)
When illuminated fl ashing (always with the DISABLEMENT light) it indicates the Output to Fire Alarm
Fault/Dis
Routing Equipment is disabled.
(amber)
When illuminated steady (always with the FAULT light) it indicates that there is a fault at the Fire Alarm
Fault/Dis
Routing Equipment).
(amber)
When illuminated it indicates the battery or mains supply to the panel has failed.
Power Fault
(amber)
When illuminated (always with either the FAULT light or the DISABLEMENT light) it indicates that there is a sounder
Sounder
fault (fl ashing indication) or sounder disablement (steady indication).
(amber)
8
NA The Zone indicators are not applicable for a Network node.