How To Edit A Zone Label; How To Edit A Local Panel Label - Honeywell GENT Operating Instructions Manual

How to edit a zone label

How to edit a zone label
This operation is not applicable for a Network Node.
NA
Each zone can be given a label and an entered label can be
modifi ed. To edit a zone label you will need to know the zone number.
You can fi nd this information in the site specifi c documentation, held
by the person responsible for the fi re alarm system.
a. Press the MENU ON/OFF button.
b. Press the F2 button to select [Set Up].
c. Press the F4 button to select [UserCode]. Notice a message on
the display 'Enter access code', followed by a fl ashing cursor. Use
the keypad to input your PIN and then press Enter button.
d. Press the F4 button once to select <etc>.
e. Press the F1 button to select [Modify]. Notice 'Modify' appears on
the display.
f. Press the F1 button to select [Label]. Notice 'Label' appears on
the display.
g. Press the F4 button once to select <etc>.
h. Press the F1 button to select [Zone]. Notice 'Zone' followed by a
fl ashing cursor appears on the display. Using the keypad enter a
number from a range 1 to128.
i. Press the F2 button to select [Enter]. Notice the previous label
appears on the display with a fl ashing fi rst character to prompt you
to edit the label. If there is no label then the line is blank.
j. Using the keypad to enter a label of up to 32 characters in length
and then press the Enter button.
34

How to edit a local panel label

A label is normally given to the control panel to
identify its location in a network. A previously entered
label can be modifi ed.
a. Press the MENU ON/OFF button.
b. Press the F2 button to select [Set Up].
c. Press the F4 button to select [UserCode]. Notice
a message on the display 'Enter access code',
followed by a fl ashing cursor. Use the keypad to
input the PIN and then press Enter button.
d. Press the F4 button once to select <etc>.
e. Press the F1 button to select [Modify]. Notice
'Modify' appears on the display.
f. Press the F1 button to select [Label]. Notice
'Label' appears on the display.
g. Press the F4 button once to select <etc>.
h. Press the F2 button to select [Local]. Notice
'local' appears on the display.
i. Press the F2 button to select [Enter]. Notice
the previous label appears on the display with a
fl ashing fi rst character to prompt you to edit the
label. If there is no label then the line is blank.
j. Using the keypad to enter a label of up to 40
characters in length and then press the Enter
button.