Optional Hard Drive Backplane Assembly (Top); Standard Hard Drive Backplane Assembly (Bottom) - HP ProLiant DL360 G7 Maintenance And Service Manual

Optional hard drive backplane assembly (top)

To remove the component:
Power down the server (on page 25).
1.
Extend the server from the rack (on page 26).
2.
Remove the access panel
3.
Remove the hard drives from hard drive bays 5, 6, 7, and 8
4.
30).
If installed, remove the BBWC battery pack or the FBWC capacitor pack
5.
FBWC capacitor
Remove the air baffle
6.
Remove all fan modules
7.
Remove the fan blank
8.
Disconnect the hard drive data cable and the hard drive power cable from the optional hard drive
9.
backplane and the system board
Remove the optional hard drive backplane.
10.
To replace the component, reverse the removal procedure.

Standard hard drive backplane assembly (bottom)

To remove the component:
Power down the server (on page 25).
1.
Extend the server from the rack (on page 26).
2.
Remove the access panel
3.
Remove all hard drives
4.
If installed, remove the BBWC battery pack or the FBWC capacitor pack
5.
FBWC capacitor
("Access panel" on page 28).
pack" on page 37).
("Air baffle" on page 38).
("Fan module" on page 35).
("Fan blank" on page 36).
("Hard drive backplane
("Access panel" on page 28).
("SAS and SATA hard
pack" on page 37).
("SAS and SATA hard
cabling" on page 58).
drive" on page 30).
Removal and replacement procedures 42
drive" on page
("BBWC battery pack or
("BBWC battery pack or