Access Panel; Hard Drive Bezel Blanks - HP ProLiant DL360 G7 Maintenance And Service Manual

WARNING:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at
•
all times.
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed
•
against it. Pay particular attention to the plug, electrical outlet, and the point where the
cord extends from the server.
WARNING:
internal system components to cool before touching them.
CAUTION:
removed. Operating the server in this manner results in improper airflow and improper
cooling that can lead to thermal damage.

Access panel

WARNING:
internal system components to cool before touching them.
CAUTION:
removed. Operating the server in this manner results in improper airflow and improper
cooling that can lead to thermal damage.
To remove the component:
Power down the server (on page 25).
1.
Extend the server from the rack (on page 26).
2.
Open the locking latch, slide the access panel to the rear of the chassis, and remove the access
3.
panel.
If the locking latch is locked use a T-15 Torx screwdriver to unlock the latch.
To replace the component:
Place the access panel on top of the server with the hood latch open. Allow the panel to extend past
1.
the rear of the server approximately 1.25 cm (0.5 in).
Push down on the hood latch. The access panel slides to a closed position.
2.
Use the T-15 Torx screwdriver provided with the server to tighten the security screw on the hood
3.
latch.

Hard drive bezel blanks

CAUTION:
unless all bays are populated with either a component or a blank.
To remove the component:
To reduce the risk of electric shock or damage to the equipment:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Do not operate the server for long periods with the access panel open or
To reduce the risk of personal injury from hot surfaces, allow the drives and the
Do not operate the server for long periods with the access panel open or
To prevent improper cooling and thermal damage, do not operate the server
Removal and replacement procedures 28