To replace the component, reverse the removal procedure.
Heatsink
To remove the component:
Power down the server (on page 25).
1.
Extend the server from the rack (on page 26).
2.
Remove the access panel
3.
If installed, remove the BBWC battery pack or the FBWC capacitor pack
4.
FBWC capacitor
Remove the air baffle
5.
Remove the heatsink.
6.
To replace the heatsink:
Use the alcohol swab to remove all the existing thermal grease from the processor. Allow the alcohol
1.
to evaporate before continuing.
Apply new grease to the top of the processor in one of the following patterns to ensure even
2.
distribution.
CAUTION:
heatsink is removed from the processor after it has been installed.
("Access
panel" on page 28).
pack" on page 37).
("Air
baffle" on page 38).
The heatsink thermal interface media is not reusable and must be replaced if the
("BBWC battery pack or
Removal and replacement procedures 45