System Board - HP ProLiant DL360 G7 Maintenance And Service Manual

Remove the battery.
7.
IMPORTANT:
configuration. After replacing the battery, reconfigure the system through RBSU.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

System board

To remove the component:
Power down the server (on page 25).
1.
Remove the server from the rack (on page 26).
2.
Remove the access panel
3.
Remove all hard drives
4.
Remove all power supplies
5.
If installed, remove the BBWC battery pack or the FBWC capacitor pack
6.
FBWC capacitor
Remove the air baffle
7.
CAUTION:
and remove all AC power cords before removing or installing the PCI riser board assembly.
Remove the PCI riser board assembly
8.
Remove all fan modules
9.
Remove the fan blank
10.
Disconnect all cables connected to the system board
11.
more information, see "Cabling (on page 58)."
Remove the cache module
12.
Replacing the system board battery resets the system ROM to its default
("Access panel" on page 28).
("SAS and SATA hard
("Hot-plug power
pack" on page 37).
("Air baffle" on page 38).
To prevent damage to the server or expansion boards, power down the server
("PCI riser board
("Fan module" on page 35).
("Fan blank" on page 36).
("Cache module" on page 41).
drive" on page 30).
supply" on page 31).
assembly" on page 38).
("System board components" on page 69). For
Removal and replacement procedures 52
("BBWC battery pack or