Table of Contents
Advertisement
4.2 Start conditions
4.2.1
Manual starts
The irrigation program includes two types of manual starts: the manual valve start
and the manual valve group start.
The manual valve start can be found in each valve group. If you select the next tile,
the 'Assign valves' selection screen will open. Tap the valves that you want to
activate; these will be indicated in white, and then tap the 'play' button to activate
them. The irrigation program will activate the selected valves using the recipe of the
valve group from which you opened the screen and that applies for the current period.
The tile of the manual valve start will indicate when the last manual start was
performed.
If a manual valve group start is executed, the irrigation program will activate the
valves assigned to the group and apply the pre-programmed recipe. This start
program can be found on the right-hand side of the top bar
valve group by tapping the 'Play' button in the valve group activity screen. The valve
group will be activated immediately.
The screen will show which valves in the group are active. If a manual valve start is
executed, the irrigation progress of the valve group will also be displayed.
If you want to a different recipe to be applied for a manual valve start, you
can change the EC, pH and volume settings of the valve group. Don't forget to
change the settings back afterwards. An alternative method is to assign the
desired valves to a group that is still 'free'. You can program different recipe
settings for this group without changing your standard recipes.
4.2.2
Pre-programming start conditions
The irrigation program includes a number of start conditions that can be pre-set:
HortiMaX-Go!
. You can activate a
23
Advertisement
Table of Contents
