Table of Contents
Advertisement
To enable automatic control, certain control values need to be set. You can do
this on the stage screen that can be accessed from the various control screens
of each zone.
Other settings can be found under the control-specific tiles
Fixed positions are not adjusted for the climate conditions inside your
greenhouse and apply for the entire day. Fixed position control is designed to
achieve a desired position quickly without changing any of the other software
settings. Unlike with the manual control mode on the switch cabinet, the gale,
rain and frost overrides will continue to be applied if fixed positions have been
selected.
3.2 Stage control
3.2.1
General information
The HortiMaX-Go! controls the greenhouse climate based on pre-defined 'stages'. The
stage screen is represented by the icon
other control screens.
The stage screen is where you set:
The desired temperature and humidity (target values)
How the temperature and humidity are to be controlled (controls)
When the above settings should apply (periods)
The stage screen allows you to enter and adjust the temperature and humidity
settings. Temperature control works based on three possible situations (called
stages): the temperature is too low, the temperature is acceptable or the
temperature is too high. When it is too cold, the heating stage
when it is too hot the cooling stage
acceptable, the neutral stage will be active
HortiMaX-Go!
. You can open this screen from the various
will be active. When the temperature is
.
,
.
will be active, and
11
Advertisement
Table of Contents
