Table of Contents
Advertisement
HortiMaX-Go!
3
Setting up climate
control
Once your HortiMaX-Go! has been commissioned, all the connected controls are set to
safe fixed positions. Vents and screens are set to 0%. Various other equipment such
as heaters or the cooling system are switched off. To enable automatic climate
control, you need to complete two steps: first set the desired control values
(temperature, relative humidity (RH) , Watts, CO
), and then switch the system to
2
automatic control.
Irrigation control is not activated automatically. To activate it, you must first set the
start conditions for irrigation and the fertigation recipes (specifying the ratios in
which your fertilizers are to be dosed). How to set up automatic irrigation control is
described in
"Setting up irrigation control" on
page 20. This chapter first describes
how to set up and activate automatic climate control.
3.1 Fixed position control
The various climate control components are set to a fixed position (0 or off) by
default. On the stage screen
, you can change the fixed position of each zone and
control. If you tap the 'Hand' icon (on the right-hand side
of the top bar), an
additional screen will open showing all the connected climate controls.
Fixed position screen:
If you tap a value, a screen will open where you can activate automatic control
or
select a fixed position.
10
Advertisement
Table of Contents
