Rear speakers
NOTE:
The rear speaker spare part kit includes the cables.
Description
For use only on computer models equipped with a graphics subsystem with discrete memory
For use only on computer models equipped with a graphics subsystem with UMA memory
Before removing the rear speakers, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3.
Remove the bottom cover (see
a.
Battery (see
b.
Solid-state drive (see
c.
WLAN module (see
d.
Fans (see
e.
System board (see
Remove the rear speakers:
1.
Release the Mylar shielding (1) and tape that secures the rear speaker cable to the keyboard/top cover.
2.
Remove the rear speakers (2).
Reverse this procedure to install the rear speakers.
56
Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
33)
Solid-state drive on page
WLAN module on page
Fans on page
38)
System board on page
30), and then remove the following components:
34)
35)
47)
Spare part number
928527-001
928528-001