Table of Contents
Advertisement
Rear speakers
NOTE:
The rear speakers are included in the Speaker Kit, spare part number 665610-001.
Before removing the rear speakers, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Optical drive (see
●
Hard drive (see
●
WLAN module (see
●
Keyboard (see
●
Top cover (see
●
System board (see
Remove the rear speakers and cables:
1.
Close the computer.
2.
Turn the computer upside down, with the front toward you.
3.
Remove the two Phillips PM2.5×5.0 screws (1) and the three Phillips PM2.5×3.0 screws (2) that
secure the rear speakers to the computer.
4.
Turn the computer right side up, with the front toward you.
94
Chapter 4 Removal and replacement procedures
Battery on page
47), and then remove the following components:
Optical drive on page
Hard drive on page
51)
WLAN module on page
Keyboard on page
59)
Top cover on page
62)
System board on page
48)
56)
81)
Advertisement
Table of Contents
