Wireless Antenna - HP Envy 13 Maintenance And Service Manual

Wireless antenna

NOTE: The Wireless Antenna Kit includes the left and right wireless antenna cables and transceivers.
Description
For use only on computer models equipped with a graphics subsystem with discrete memory
For use only on computer models equipped with a graphics subsystem with UMA memory
Before removing the wireless antenna, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
3. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. WLAN module (see
d. Fans (see
e. System board (see
Remove the wireless antenna:
1. Release the tape (1) that secures the wireless antenna cables to the keyboard/top cover.
2. Detach the wireless antenna transceivers (2) from the keyboard/top cover. (The wireless antenna
transceivers are attached to the keyboard/top cover with double-sided adhesive.)
Bottom cover on page
Battery on page 33)
Solid-state drive on page
WLAN module on page
Fans on page 38)
System board on page
30), and then remove the following components:
34)
35)
47)
Component replacement procedures
Spare part number
937093-001
936025-001
57