Rear Speakers - HP ENVY 13 Maintenance And Service Manual

Rear speakers

Description
Rear speakers (include left and right front speakers, cables, and two rubber isolators)
Before removing the rear speakers, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the system board (see
Remove the rear speakers:
1. Release the rear speaker cable (1) from the retention channel/retention clips built into the keyboard/
top cover.
2. Remove the two Phillips M2.0×5.7 shoulder screws (2) that secure the rear speakers to the keyboard/
top cover.
3. Remove the rear speakers (3).
NOTE:
isolators (4). These isolators are critical to the performance of the rear speakers. The absence of these
isolators or damage to them can degrade the rear speaker performance.
Reverse this procedure to install the rear speakers.
Bottom cover on page
System board on page
When removing the rear speakers, make note of the location and condition of the two rubber
26).
Battery on page 27).
33).
Component replacement procedures
Spare part number
L19531-001
41