Preparation
Please have the following ready beforehand.
•
Replacement backlight
•
One pair of clean (preferably new) cotton gloves.
•
Phillips screwdriver (no.2)
PS3710A-T41,PS3710-T41-24V,
PS3711A-T41,PS3711-T41-24V
PS3710A-T42,PS3710-T42-24V,
PS3711A-T42,PS3711-T42-24V
4.5.1
PS-3710A Series
Be sure to wear gloves when exchanging the backlight, and follow the following procedures.
(1) Turn OFF the power switch of the PS-A and remove the power cable.
(2) Remove the PS-A unit from the equipment (panel etc.) to which the unit has been incorporated, and
place the PS-A unit on a flat, level surface facing the display face downwards.
(3) Remove the PS-A's rear cover.
SEE
(4) Detach the FDD unit cable and power cable from the connector, and remove the two attachment screws
to detach the FDD unit.
Attachment Screw
Power Cable
• The appropriate replacement backlight depends on your PS-A model.
PS-A
• Be sure to perform the backlight changeover on a flat, level surface. This will
prevent damage to the PS-A unit and the accidental cutting of any of its power
cord.
• Be sure to protect the display surface to prevent damage during the operations.
3.2.1 Removal/Attachment the Rear Cover (page 3-6)
Power Connector
Replacement Backlight
CA3-BLU15-01
CA7-BLU15-01
Rear of FDD Drive
FDD Drive Connector
Attachment Screw
FDD unit Cable
Chapter 4 Maintenance
4-7