Table of Contents
Advertisement
PS-3710A/PS-3711A Series Hardware Manual
3.2.7
HDD/SSD Unit Installation
Shock Danger! Be sure to unplug the PS-A unit from its power supply prior to installing the
HDD unit.
When attaching the HDD/SSD to the PS-3710A
(1) Place the PS-A unit face down and unscrew five (5)
attachment screws (See diagram).
(2) Lift the PS-A unit's Rear Cover off of the PS-A unit.
(3) Insert the HDD/SSD unit cable connector completely
into the IDE I/F. Attach HDD/SSD unit using four (4)
attachment screws. The torque should be 0.5 to 0.6 N
(4) Replace the PS-A unit's Rear Cover and reattach five (5)
attachment screws. The torque should be 0.5 to 0.6 N
3-14
• Since the HDD/SSD unit is a precision instrument that has a low resistance to
shocks, be sure it is neither hit by nor pressed strongly against another object
when installing it.
• Even when the PS-A unit's screen display disappears, the power might be
distributed inside (such as the "Standby" status etc.). Be sure to confirm that the
power supply switch on the rear side of the PS-A unit is OFF.
PS-A unit's Rear Cover
•
m.
•
m.
IDE I/F
Advertisement
Table of Contents
