Fitting The Brackets - REMEHA P 420 Assembly Instructions Manual

2

Fitting the brackets

Front - Rear
P 420-8 - P 420-10 - P 420-12 - P 420-14
Fit the 2 rear holding brackets and secure them to the frame.
Use the corresponding holes following the indication on the frame.
Position the lower insulation (fabric to the top) package CS 51 to CS 57. If necessary, adapt the length of or fold the lower insulation after
completing assembly of the casing.
3 Positioning the frame and the rear section
Establish the location of the frame on the basis of the opening direction of the furnace door and the length of the burner.
Position the rear section on the frame and prop it up.
Affix it to the brackets (2 screws HM 12x40/40 + 4 washers L12 + 2 nuts HM12).
Around every 100 mm, place points of silicon mastic (1 tube delivered with the accessories package CS 20) in the leak proofing groove in
the section using a gun.
Carefully introduce the leak proof thermocord into the leak proofing groove.
do not pull on the seal while inserting it. Otherwise, you may stretch it and reduce its thickness. You must not make the junction
point with the thermocord in the lower part of the section.
6
P 420-9 - P 420-11 - P 420-13
P 420 02/04/08 - 300016854-001-A