REMEHA P 420 Assembly Instructions Manual page 22

27 Assembly of the rear panels Package RB2
Hook the lower rear panel
Put in place the 2 self-tapping screws Ø 3.9 x 12.7 + serrated washers without tightening them.
Hook the left and right upper rear panels to the 2 bushes on the side panels and secure each one to the lower rear panel using 2 self-
tapping screws Ø 3.9x12.7 + serrated washers.
Fix to the rear top panel (2 self-tapping screws Ø 3.9x12.7 + serrated washers).
Hook the additional lower rear panel onto the 2 screws on panel
Fit the lower rear panel (2 screws + Serrated washers).
28 Mounting of the front casing panels
Affix the lower front panel to the cross-bar (2 screws ø 3.94x12.7
+ serrated washers).
Position the lower cross-bar and affix to the side panels using 2
self-tapping screws ø 3.94x12.7 + serrated washers.
Position the panel for combustion chamber door and secure
using 2 screws HM12x25 + flat washers.
22
to the 2 bushes on the side panels.
and tighten these 2 screws to secure the panel
P 420
to .
02/04/08 - 300016854-001-A