EdgeStar CWR461DZ Service Manual page 14

3. DISASSEMBLY
(Models： CWR1431TZ )
PCB board for lower zone
1. Remove five screws from the air duct board (figure 57)
Screw
2. Pull out the air duct board cover
3. Unplug all cable connectors. (figure 59)
4. The control board is like below. (figure 60)
5.Remove the six screws from Air duct board C(figure 61)
Figure 57
(figure 58)
Figure 58
Figure 59
Figure 60
Figure 61
- 14 -
6.Loosen the display PCB board connector. Pull out the air
duct board C.Take out the front display PCB board cover from
left side(figure 62)
7. Loosen the display PCB board fixer and take out the PCB
board.(figure 63)
8. The display board is like below. (figure 64)
Display PCB board in upper zone
9. Remove the screws form air duct board (figure 65)
Screw
10. Pull out the air duct board cover
Front cover
Figure 62
Figure 63
Figure 64
Figure 65
(figure 66)
Figure 66