EdgeStar CWR461DZ Service Manual page 11

3. DISASSEMBLY
LED light in lower zone
1. Remove four screws from the middle air duct board (figure
26)
2.
Remove the middle air duct board cover. Unscrew four
screws (figure 27)
Take out the complete middle air duct board
3.
Pull out the LED light connector
5.
5.Loosen the LED light five fixer. Take out the LED light.
(figure 30)
6. The LED light is like below. (figure 31)
Screw
Figure 26
Screw
Figure 27
.
(figure 28)
Figure 28
(figure 29)
Light connector
Figure 29
Figure 30
- 11 -
Figure 31
(Models： CWR1431TZ )
LED light in upper zone
1. Loosen one screws. (figure 32)
2. Unplug the led light connector. (figure 33)
3. Loosen two screws. (figure 34)
Screw
4. The LED light is like below. (figure 35)
LED light in middle and lower zone
1. Remove five screws（figure 36)
Figure 32
connector
Figure 34
Figure 35
Screw
Figure 36
Figure 33