EdgeStar CWR461DZ Service Manual page 10

3. DISASSEMBLY
2. Unplug the led light connector. (figure 15)
3. Loosen two screws. (figure 16)
4. The LED light is like below. (figure 17)
LED light in lower zone
3. Loosen one screws. (figure 18)
4. Unplug the led light connector. (figure 19
Figure 15
Figure 16
Figure 17
Figure 18
connector
Figure 19
- 10 -
7. Loosen two screws. (figure 20)
Screw
(Models：CWR1551DD )
LED Light in upper zone
1. Loosen four screws. (figure 21)
2. Pull out the electrical box. (figure 22)
3. Unplug all cable connectors. (figure 23)
4. Press the plastic nail supporting the control board with
forefinger and thumb. (figure 24)
5. The LED light is like below. (figure 25)
Figure 20
Figure 21
Screw
Figure 22
Figure 23
Figure 24
Figure 25