Cleaning - Groen TDB-20 TA/2 Operator's Manual

A. Suggested Tools & Materials.
1. A good stainless steel cleaner.
2. Stiff brush.
3. Sanitizer Solution.
B. Precautions
WARNING
BEFORE CLEANING ANY PART OF THE
MIXER, OTHER THAN THE AGITATOR,
SHUT OFF ALL ELECTRIC POWER TO THE
COOKER/M IXER AT
BREAKER OR FUSE BOX, TO AVOID
POSSIBLE ELECTRIC SHOCK.
KEEP WATER AND SOLUTIONS OUT OF
THE CONTROLS, ELECTRICAL WIRING,
AND DRIVE MECHANISM. NEVER SPRAY
OR HOSE THE MIXER.
C. Procedure
1. Wash the agitator as soon as possible after
use. If the unit is in continuous use,
thoroughly clean and sanitize all parts of the
mixer at least once every 12 hours
2. Disassemble the scrapers and clean them
along with the rest of the agitator, then
reassemble them.
WARNING
AVOID CONTACT WITH ANY CLEANER, AS
RECOMMENDED BY
CAREFULLY READ THE WARNINGS AND
FOLLOW THE DIRECTIONS ON THE LABEL
OF THE CLEANER. MANY CLEANERS ARE
HARMFUL TO THE SKIN, EYES, MUCOUS
MEMBRANES, AND CLOTHING.
3. Prepare a hot solution of the cleaning
compound as instructed by the supplier.
Wash the agitator parts and rinse them well.
Use a cloth moistened with the cleaning
solution to clean other parts of the mixer.

Cleaning

T HE CIRCUIT
THE SUPPLIER.
9
OM-TDB TA/2
4. To remove materials stuck to the agitator,
use a brush, sponge, cloth, plastic or rubber
scraper, or plastic wool along with the
cleaning solution. To make washing easier,
let the cleaning solution soak into the
residue. When you clean the stainless steel
parts, do not use any abrasive material (like
metal sponges or scouring powder) or metal
implement (like a spoon, scraper, or wire
brush) that might scratch the surface.
Scratches make the surface hard to clean
and provide places for bacteria to grow. Do
not use steel wool, which may leave
particles imbedded in the surface and cause
eventual corrosion and pitting.
5. As part of the daily cleaning program, clean
all surfaces that may have been soiled.
Remember to check such parts as the back
and underside of the drive housing.
6. When the agitator needs to be sanitized, use
a sanitizing solution equivalent to one that
supplies 100 parts per million available
chlorine. Obtain advice on the best sanitizing
agent from your supplier of sanitation
products. Following the supplier's directions,
apply the sanitizer after the agitator has
been washed, then rinse off the sanitizer
completely. It is recommended that the
agitator be sanitized just before use.
CAUTION
NEVER LEAVE A SANITIZER IN CONTACT
WITH THE SURFACE OF STAINLESS
STEEL LONGER THAN
L O N G ER CO NT ACT
CORROSION.
7. The exterior of the unit may be polished with
a good quality stainless steel cleaner.
Cleaning procedures for the kettle component of
your cooker/mixer are described in the separate
kettle manual.
20 MINUTES.
C AN C AU S E