Operation - Groen TDB-20 TA/2 Operator's Manual

OM-TDB TA/2
TURN OFF AGITATOR BEFORE ADDING INGREDIENTS OR INSPECTING KETTLE CONTENTS.
DO NOT WEAR LOOSE CLOTHING OR JEWELRY AROUND OPERATING MIXER KETTLE. KEEP
WELL CLEAR OF ROTATING MIXER ARMS AND PADDLES AT ALL TIMES.
1. Before you operate the mixer, make sure
that the agitator is firmly connected with the
drive shaft and properly positioned in the
kettle. The agitator must be positioned so
every scraper blade touches the kettle
during at least part of each revolution. To
connect the agitator:
a. Slip-on Coupling: Slide the coupling up
onto the shaft as far as it will go. Then
turn the agitator and pull it down, so that
the drive pin on the shaft becomes firmly
seated against the end of the J-slot.
2. If the mixer has been tilted up, lower it into
operating position.
WARNING
THE UNIT IS EQUIPPED
AUTOMATIC TILT CUTOFF SWITCH. IF
POWER IS ON WHEN A TILTED MIXER IS
LOWERED INTO OPERATING POSITION,
THE MIXER CAN
START.
3. Turn on electric power to the unit at the
circuit breaker or fuse box.
4. Switch on the drive.
5. Set the desired mixing speed.
CAUTION
STARTING WITH THE MIXER SET AT HIGH
SPEED MAY CAUSE MATERIAL TO SPILL
OUT OF THE KETTLE ON VARIABLE
SPEED UNITS.

Operation

WARNING
WITH AN
AUTOMATICALLY
8
a. On a variable speed drive with electrical
speed control, turn the speed adjustment
knob.
CAUTION
UNDER HEAVY LOAD DO NOT RUN THE
MIXER CONTINUOUSLY
THAN 5% OF FULL SPEED. SLOWER
OPERATION COULD DAMAGE THE SPEED
CONTROL.
6. To stop the mixer, switch off the drive. Set
the drive to low speed before switching it off.
If the cooker/mixer will be cleaned or
serviced, or will not be used for a week or
longer, cut off all power supplies to the unit
at the circuit breaker or fuse box.
7. Switch off the drive, before you tilt the mixer.
To tilt the mixer, first unlatch it (See
Photograph). For some units, you may need
to tilt the kettle forward slightly to let the
agitator clear the kettle wall as you tilt the
mixer.
8. As you tilt the mixer out of the kettle, clean
any clinging product from the agitator, so
product will not drip onto the outside of the
kettle or surroundings, and so the weight of
product will not make the mixer fall down.
To operate the kettle component of your
cooker/mixer, see the separate kettle manual.
AT SLOWER