Cleaning - Groen TDB/8-20-CFC Operator's Manual

1. Suggested Tools:
a. Cleaner, such as Klenzade HC-10 or
HC-32 from ECOLAB, Inc.
b. Kettle brushes in good condition.
c. Sanitizer such as Klenzade XY-12.
d. Film remover such as Klenzade LC-30.
2. Precautions
Before cleaning, shut off the kettle by turning
the thermostat dial to "OFF" and unplug the
unit or shut off its electric power at a remote
switch, such as the circuit breaker.
WARNING
KEEP WATER AND SOLUTIONS AWAY
FROM CONTROLS AND ELECTRICAL
EQUIPMENT. NEVER SPRAY THE KETTLE
BODY OR ELECTRICAL CONNECTIONS.
CAUTION
MOST CLEANERS ARE HARMFUL TO THE
SKIN, EYES, MUCOUS MEMBRANES, AND
CLOTHING. TAKE PRECAUTIONS. WEAR
RUBBER GLOVES, GOGGLES OR FACE
SHIELD, AND PROTECTIVE CLOTHING.
READ THE WARNINGS AND FOLLOW THE
DIRECTIONS ON THE CLEANER LABEL.
3. Procedure
a. Clean food-contact surfaces as soon as
possible after use. If the unit is in
continuous use, thoroughly clean and
sanitize the interior and exterior at least
once every 12 hours.
HOT HOT
SURFACES SURFACE
WARNING
AVOID ANY DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN BURNS.

Cleaning

b. Scrape and flush out food residues. Be
careful not to scratch the kettle with
metal implements.
c. Prepare a hot solution of the detergent/
cleaning compound as instructed by the
supplier. Clean the unit thoroughly. A
cloth moistened with cleaning solution
can be used to clean controls and
electrical conduits.
d. Rinse the agitator parts and the inside of
the kettle thoroughly with hot water to
remove every trace of detergent. Drain
them completely and allow them to AIR
dry or wipe them dry. (The agitator may
be cleaned in a dishwasher).
e. As part of the daily cleaning program,
clean soiled external and internal
surfaces. Remember to check the sides
and back of the unit.
f. To remove stuck materials, use a brush,
sponge, cloth, plastic or rubber scraper,
or plastic wool with the cleaning solution.
Use a sponge, cloth or plastic brush to
clean the kettle.
Scrapers or steel wool can harm the kettle
surface.
7
OM-TDB/8-20-CFC
OM-TDB/8-20-CFC
OM-TDB/8-20-CFC 7