Sierra Wireless MC5725 Hardware Integration Manual page 87

Note: This procedure describes
steps using the "Power Meter:
Gigatronics 8651A" (with Option
12 and Power Sensor 80701A).
Rev 1.9.1 Feb.09
In the event of a discrepancy in values between this guide and the Product Specification Document (PSD), the PSD takes precedence.
Table 8-1: Test settings for MC87xx transmission path testing
Mode Test category
WCDMA Band
Channel
GSM Band
Channel
To test the DUT's transmitter path:
1. Set up the power meter:
a.
b.
c.
Prepare the DUT using the following AT commands:
2.
a.
b.
c.
d.
e.
f.
g.
Proprietary and Confidential
850 900
22 29
4182 2812
18 10
190 65
Make sure the meter has been given sufficient time to
warm up, if necessary, to enable it to take accurate
measurements.
Zero‐calibrate the meter.
Enable MAP mode.
AT!UNLOCK="<lockCode>"
command set)
or
AT!ENTERCND
AT!DAFTMACT
AT!DASBAND=<bandValue>
· See Table 8‐1 for appropriate <bandValue> values
AT!DASCHAN=<channel>
· See Table 8‐1 for appropriate <channel> values
(GSM mode only)
AT!DAGSTXFRAME=0, 1, 3000, 0
AT!DASTXON
(Turns on the transmit path)
(WCDMA mode only)
AT!DAWSTXCW=0
(Use a modulated carrier)
Testing
Bands
1800 1900
15 9
9400 9750
11 12
697 661
(Unlocks extended AT
(Enters test mode)
2100
87