Suggested Manual Functional Test Procedure; Suggested Test Plan Procedure - Sierra Wireless MC5725 Hardware Integration Manual

CDMA and GSM / UMTS Mini Card Hardware Integration Guide
80
In the event of a discrepancy in values between this guide and the Product Specification Document (PSD), the PSD takes precedence.
Suggested manual functional
test procedure
This section presents a procedure for performing a basic
manual functional test on a laboratory bench using the Mini
Card and a Mini Card Dev Kit. When you have become
familiar with the testing method, use it to develop your own
automated production testing procedures.
Suggested tests
Consider the following tests when you design your production
test procedures for devices with the MC57xx and/or MC87xx
installed.
Visual check of the module's connectors, RF assemblies, and
•
audio assemblies (if applicable)
Module is operational
•
• USB connection is functional
• LED is functional
(module power down)
• W_Disable#
• Firmware revision check
• Rx tests on main and auxiliary paths
• Tx test
Audio (microphone and speaker) tests (for voice‐enabled
•
modules)

Suggested test plan procedure

Note: The following is a suggested outline for a relatively compre-
hensive test plan—you must decide which tests are appropriate for
your product.
This is not an exhaustive list of tests—you may wish to add additional
tests that more fully exercise the capabilities of your product.
Note: You may choose to create and run a test program that
automates portions of the test procedure.
Using an appropriate Dev Kit‐based test station (a suggested
setup is described in
and referring to the appropriate standard and extended AT
command references:
1. Visually inspect the module's connectors and RF assem‐
blies for obvious defects before installing it in the test
station.
Proprietary and Confidential
Suggested testing equipment
on page 97),
2130114