CDMA and GSM / UMTS Mini Card Hardware Integration Guide
Note: You can perform these
tests using appropriate AT
commands.
Note: Typically, you need to
pass certification testing of your
device with the integrated
module one time only.
78
In the event of a discrepancy in values between this guide and the Product Specification Document (PSD), the PSD takes precedence.
Test procedure
The following is a suggested acceptance testing procedure
using Sierra Wireless' Watcher software:
Test 1: Check power-up and initialization
After installing the module, start the test system.
1.
2.
Launch Watcher.
3.
Check the LED—if the LED is off, there is a problem with
the module or with the connection to the LED.
Test 2: Check version numbers
From Watcher, select
1.
2.
Verify that the firmware version in the
correct.
About
Close the
3.
If the module fails either of these tests, or is not recognized by
Watcher:
Replace the module with one that is known to work
1.
correctly and repeat the tests.
2.
If the tests are successful, reinstall the original module and
repeat the tests.
If the module still does not work correctly, contact your
account manager.
Certification testing
When you produce a host device with an embedded Sierra
Wireless module, you must obtain certifications for the final
product from appropriate regulatory bodies in the jurisdic‐
tions where it will be distributed.
Note: The module itself (MC57xx, MC87xx) has been certified
already—only the integrated device needs certification.
The following are some of the regulatory bodies from which
you may require certification—it is your responsibility to make
sure that you obtain all necessary certifications for your
product from these or other groups:
•
FCC (Federal Communications Commission—
Industry Canada (
•
CSA (Canadian Standards Association—
•
Factory Mutual (FM Global—
•
Proprietary and Confidential
Help > About
.
window.
www.ic.gc.ca)
www.allendale.com
About
window is
www.fcc.gov
)
www.csa.ca
)
)
2130114