Testing Rf Transmission Path-Mc57Xx - Sierra Wireless MC5725 Hardware Integration Manual

Note: This procedure describes
steps using the "Power Meter:
Gigatronics 8651A" (with Option
12 and Power Sensor 80701A).
Rev 1.9.1 Feb.09
In the event of a discrepancy in values between this guide and the Product Specification Document (PSD), the PSD takes precedence.
When prompted, enter your user password to begin the
2.
download and installation. When minicom is installed, the
shell prompt appears.
Configure minicom to communicate with your modem:
3.
a. Start minicom with the following command:
minicom -s
Use the down‐arrow key to select the "Serial port setup"
4.
option.
Refer to Step 5 on page 81 to identify the device file handle
5.
(/dev/ttyUSBn) to use for AT commands.
6. Indicate the file handle to use for AT commands — e nter
and then replace the serial device string with the AT file
handle (for example, /dev/ttyUSB4 for an MC8792V as
shown in the example in Step 5 on page 81).
7. Press Enter twice.
Use the down‐arrow key to select
8.
Exit
9. Select .
Testing RF transmission path—MC57xx
Note: This procedure segment is performed in Step
Suggested test plan procedure (page
To test the DUT's transmitter path:
Set up the power meter:
1.
a. Make sure the meter has been given sufficient time to
warm up, if necessary, to enable it to take accurate
measurements.
b. Zero‐calibrate the meter.
Enable MAP mode.
c.
Proprietary and Confidential
Testing
Save setup as dfl
.
13 of the
84).
A
85