Removing An Expansion Card Riser; Installing An Expansion Card Riser - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 63. Installing expansion card into full height X1 riser
Next steps
1 If applicable, connect the cables to the expansion card.
2 If applicable, install air shroud.
3 Follow the procedure listed in
4 Install any device drivers required for the card as described in the documentation for the card.

Removing an expansion card riser

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Disconnect any cables connected to the expansion card.
Step
Hold the touch points, and lift the expansion card riser, from the riser connector, on the system board.
Next step
Install the expansion card riser.

Installing an expansion card riser

Prerequisite
1 Follow the safety guidelines listed in
After working inside your system.
Safety instructions.
Before working inside your
Safety instructions.
system.
Installing and removing system components 75