Dell EMC PowerEdge R440 Installation And Service Manual page 101

CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
2 Holding the system board holder, push the system board toward the back of the system till it is seated.
3 Using Phillips #1 screwdriver, tighten the screws to secure the system board to the chassis.
Figure 92. Installing the system board
Next steps
1 Install the Trusted Platform Module (TPM).
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2 Replace the following:
a Internal PERC riser
b Internal USB key (if applicable)
c USB 2.0 module (if applicable)
d IDSDM/vFlash module card
e All expansion cards and risers
f Processors and heat sink modules
g Processor blanks (if applicable)
h Memory modules
i LOM riser card
j Air shroud
3 Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4 Follow the procedure listed in
5 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag by using the Easy Restore feature section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Replacing the Trusted Platform Module section.
6 Import your new or existing iDRAC Enterprise license.
After working inside your system.
Installing and removing system components 101