Idrac Direct Led Indicator Codes - Dell EMC PowerEdge R440 Installation And Service Manual

Table 5. Right control panel
Item
1
2
3
4

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. The
following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 6. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two
seconds and off for two
seconds)
Turns off
12 Dell EMC PowerEdge R440 overview
Indicator or button
Power button
USB port
iDRAC Direct LED
iDRAC Direct port
Condition
Indicates that the laptop or tablet connected is recognized.
Indicates that the laptop or tablet is unplugged.
Icon
N/A
Description
Indicates if the system is turned
on or off. Press the power
button to manually turn on or off
the system.
NOTE: Press the power
button to gracefully shut
down an ACPI-compliant
operating system.
The USB ports are 4-pin, 2.0-
compliant. These ports enable
you to connect USB devices to
the system.
The iDRAC Direct LED indicator
lights up to indicate that the
iDRAC Direct port is actively
connected to a device. For more
information, see the iDRAC
Direct LED indicator codes
section.
The iDRAC Direct port is micro
USB 2.0-compliant. This port
enables you to access the iDRAC
Direct features. For more
information, see the iDRAC
User's Guide at Dell.com/
idracmanuals.