ASCOM 9d24 MkllMessenger User Manual page 46

User Manual
9d24 Mkll Cordless Telephone
Note: The Power Supply Module is adapted for the European market (UK excepted)
Copying procedure
1 Remove the battery pack on the master handset (i.e. the handset with the software
that is to be copied).
2 Press and hold down key 1 on the handset while replacing the battery pack again.
Do not release key 1 until "Wait..." appears in the display.
3 When "Wait... disappears, place the handset in the master slot on the charging
rack, see
4 Remove the battery pack on the slave handset (i.e. the handset that is to be
updated).
5 Press and hold down key 4 on the handset while replacing the battery pack again.
Do not release key 4 until "Load SW:...Exit" appears in the display.
6 Place the handset in the slave slot to the left of the master slot, see figure below.
Make sure that the handset locks into position. "Erase memory" is shown in the
slave handset display. Then the copying process starts.
Figure 10. Master and slave slots in a Charging Rack for copying of software.
When "Ok" appears in the bottom of the display the copying is finished.
If the copying was not successful "Fail" will appear in the display. Remove the
handset from the charging rack and repeat from point 4.
7 Remove the handset from the charging rack. "Exit Ok" is shown in the display.
Press volume key up to start up the handset. To continue copying software to
additional slave handsets, keep the master handset in the charging rack and repeat
from point 4.
8 When the copying procedure is finished remove the master handset from the
charging rack. Press volume key up to start up the handset.
2006-03-20/ Ver. PA8
PRELIMINARY
figure 10 on page 41. Make sure that the handset locks into position.
slave
slot 1
slave
slot 2
master
slot 1
master
slot 2
TD 92333GB
41