Alarm Operation; Push-Button Alarm; Test Alarm; No-Movement Alarm - ASCOM 9d24 MkllMessenger User Manual

User Manual
9d24 Mkll Cordless Telephone
The second push-to-talk function is used in DECT systems that are connected to systems
where only one person is allowed to speak at the same time. The handset sends DTMF
tones to the connected system when the Mute button is pressed/released to open/close
the speech channel.
3.8

Alarm Operation

Note: 9d24 Mkll Protector only.
3.8.1

Push-button Alarm

Press the red alarm button twice within two seconds to activate the alarm. An information
text is displayed, default "Personal Alarm" is displayed. The alarm is sent to the alarm
central that distributes it further. After that the handset returns to stand-by mode. Note
that you can always trigger the alarm when you are speaking, editing your settings, or
while the phone is locked.
3.8.2

Test Alarm

Press and hold the red alarm button until the information text is displayed, default "Test
Alarm" is displayed.
3.8.3

No-movement Alarm

Note: The stand-by time will decrease by approximately 25% when the handset is
equipped with the Alarm Module.
You can activate/deactivate the alarm function in the menu, see
No-movement alarm
function, see
alarm, i.e. if it is deactivated it will be activated and vice verse. Press the Soft key, or press
and hold the Hot key, to put the alarm in operation respectively out of operation. The
"No-movement alarm on" icon on your display is an indication that the No-movement
alarm is in operation.
Send no-movement alarm
The No-movement alarm will go off when you have not moved within a preset time
(default 30 seconds). Before the alarm is activated a warning signal sounds and the "No-
movement on" icon starts to flash. If you do not cancel the alarm by pressing a key, it is
sent and "No-movement/man-down Alarm" is shown in the display.
Activate the no-movement alarm again
When the no-movement alarm has been sent, it is activated again by pressing a key or by
moving the handset.
3.8.4

Pull-cord Alarm

Note: The handset has to be equipped with the optional Pull-cord alarm sensor.
As an option a pull-cord can be attached to the handset. When the cord is removed an
alarm is generated and sent. The alarm can be triggered immediately or after a delay of
ten seconds. All depending on the parameter settings in the handset. You can activate/
deactivate the alarm function in the menu, see
2006-03-20/ Ver. PA8
PRELIMINARY
on page 31, or by programming a Soft/Hot key as a short-cut to the
6.5.8 Edit a Soft key on page 32. The Soft/Hot key changes the state of the
6.5.5 Deactivate/Activate
6.5.7 Deactivate/Activate Pull-cord alarm
TD 92333GB
16