Upgrading To Xcp 1090; Resetting The Xscf Firmware; Functionality Issues And Limitations; Limitation For Power Consumption Monitoring Function - Sun Microsystems SPARC Enterprise M3000 Product Notes

Hide thumbs Also See for SPARC Enterprise M3000:

Table of Contents

Upgrading to XCP 1090

For information about upgrading your firmware, refer to the Sun SPARC Enterprise

M3000/M4000/M5000/M8000/M9000 Servers XSCF User's Guide.

After updating the XCP firmware, use the rebootxscf(8) command to reset the

XSCF.

This section describes known issues and limitations at the time of this release.

Limitation for Power Consumption Monitoring

Function

The amount of power consumption may not be indicated correctly in the MIB

information, in the showenvironment power command output, and on the XSCF

Web in the following cases; and you should wait for one minute and check the value

again.

During the server powering on or powering off, or for a while after the power-on

■

or power-off complete

During the active replacement of power supply unit, or for a while after the active

■

replacement complete

Note – For power-on after power-off, wait at least 30 seconds before turning the

system power back on, by using the main line switch or the circuit breakers on the

distribution panel.

Sun SPARC Enterprise M3000 Server Product Notes for XCP 1090 • August 2009

Table of Contents

Do you have a question about the SPARC Enterprise M3000 and is the answer not in the manual?