Regulated Transmit Power; Use The Host Ptt Button; Set Operating Frequency; Use Large Knob To Set Frequency - XIEGU X5105 Instruction Manual

When using the AF-OUT port of the ACC interface, adjusting the volume level will do the
same for this port.

3.6 Regulated transmit power

Press the [Po] transmit power setting button, you can set the transmit power.
A. Press the [Po] button to enter the power setting state, and the screen will display the
Po power set bar table.
B. Rotate the big knob, set the power, step 0.5W.
C. When the settings are complete, press the [Po] button again, save and exit the setup
mode.
When you do not understand the current state of the antenna, minimize the set transmit
power value for the first time you use the X5105 transceiver.

3.7 Use the host PTT button

X5105 comes with a PTT button, you can start the transceiver's transmission through this
button.
Operation method:
A. Press this button to start the transmitting function.
B. Speaking into the built-in MIC hole, can be completed communications.

3.8 Set operating frequency

There are two ways to set the X5105 operating frequency, use the big knob to set the
frequency, or use the multi-function mic to set the frequency.
Operation method:
A. Use large knob to set frequency
Press the button [<] or [>], move the cursor of the frequency bit to the left or to the
right, select the frequency of the desired step.
Rotating frequency knob sets the frequency of the current step.
15