Wilson Electronics 801306 Installation Manual page 3

4.3 Indicator Lights
4.4 Installing The Wilson Cellular Inside Antenna
4.4.1 See antenna packaging for model specific instructions.
4.4.2 The inside antenna should be centered in the weak signal area. The inside antenna
should be at least 7 feet from the floor.
WARNING: The inside antenna used with this amplifier must have a separation
distance from all persons that is at least:
9 inches for the 2.5 dBi Dome antenna.
14 inches for the 7 dBi Panel antenna.
The amplifier must not be co-located or operating in conjunction with any other
antenna or amplifier.
4.5 When covering multiple areas a 1900 MHz splitter can be used to allow for more than one
inside antenna. Extension cables can also be used if the weak signal area is located far from the
location of the outside antenna. For coax runs more than 20 feet use 9913 or equivalent coax.
NOTE: For Maximum gain (60 dB), keep a separation distance of at least 50 feet
between the outside and inside antennas. Closer spacings may be used,
but may cause the amplifier to automatically reduce its gain.
NOTE: When using a Yagi antenna make sure the Yagi is pointed away from the
inside antenna.
ALL LIGHTS
LIGHT D OFF = 2 dB REDUCTION
LIGHT D & C OFF = 10 dB REDUCTION
LIGHT D, C & B OFF = 20 dB REDUCTION
LIGHT A
FCC Separation Warning

GREEN = 60 dB GAIN
RED = 40 dB REDUCTION