Ipic; Spi - Freescale Semiconductor MPC8358E Hardware Specificftion

IPIC

Figure 40 provides the AC test load for the GPIO.
15 IPIC
This section describes the DC and AC electrical specifications for the external interrupt pins of the
MPC8360E/58E.
15.1 IPIC DC Electrical Characteristics
Table 53 provides the DC electrical characteristics for the external interrupt pins of the IPIC.
Characteristic
Input high voltage
Input low voltage
Input current
Output low voltage
Output low voltage
Notes:
1. This table applies for pins IRQ[0:7], IRQ_OUT, MCP_OUT, and CE ports Interrupts.
2. IRQ_OUT and MCP_OUT are open drain pins, thus V
15.2 IPIC AC Timing Specifications
Table 54 provides the IPIC input and output AC timing specifications.
IPIC inputs—minimum pulse width
Notes:
1. Input specifications are measured from the 50% level of the signal to the 50% level of the rising edge of CLKIN. Timings are
measured at the pin.
2. IPIC inputs and outputs are asynchronous to any visible clock. IPIC outputs should be synchronized before use by any
external synchronous logic. IPIC inputs are required to be valid for at least t
in edge triggered mode.

16 SPI

This section describes the DC and AC electrical specifications for the SPI of the MPC8360E/58E.
MPC8360E/MPC8358E PowerQUICC II Pro Processor Revision 2.x TBGA Silicon Hardware Specifications, Rev. 4
58
= 50 Ω
Output
Z
0
Figure 40. GPIO AC Test Load
Table 53. IPIC DC Electrical Characteristics
Symbol
Table 54. IPIC Input AC Timing Specifications
Characteristic
= 50 Ω
R
L
Condition
V —
IH
V —
IL
I —
IN
V I = 6.0 mA
OL OL
V I = 3.2 mA
OL
OL
is not relevant for those pins.
OH
ns to ensure proper operation when working
PIWID
OV /2
DD
Min Max
2.0 OV + 0.3
DD
–0.3 0.8
— ±10
— 0.5
— 0.4
1
2
Symbol Min
t 20
PIWID
Freescale Semiconductor
Unit
V
V
μA
V
V
Unit
ns