Operation; Blending; Chopping/Grinding - Cuisinart CSB-85C Instruction And Recipe Booklet

OPERATION

BLENDING

The specially designed blade is for mixing and puréeing all kinds of
foods, including salad dressings, powdered drink products, soups and
sauces, and blended drinks like milkshakes or smoothies.
This blade mixes and stirs while adding only a minimum of air to your
mixture. A gentle up-and-down motion is all you need to make the
most flavorful, full-bodied recipes. Be careful never to remove the
blending shaft from the liquid while in operation, for it will splatter.
Tilt the pan or bowl away from you if needed to ensure the protective
blade guard on the blending shaft is fully submerged.
1. Put blending shaft into mixture to be blended.
2. Press and hold the desired speed button. Press and hold the
Lock/Unlock button on top of the motor housing. Once motor is
on, you can release the Lock/Unlock button but continue to hold
in the speed button. You can also press the Lock/Unlock button
first, holding it down as you press the speed button to turn motor
on. Do not hold power button down for more than 60 seconds at
a time.
3. Do not press the button for longer than 60 seconds at a time.
4. Unplug immediately after use.
CAUTION: DO NOT PUT FINGERS NEAR BLADE. TO DISLODGE
FOOD, UNPLUG HAND BLENDER FROM THE OUTLET FIRST.
PULSING
To pulse, press and release desired speed button, while holding down
the lock/unlock button.
CHOPPING FOOD
1. Place the work bowl on a flat, sturdy surface like a countertop.
2. Put food in the work bowl. Be sure the food is cut into small
pieces [½ to 1 inch (1.25 to 2.5 cm)], and the bowl is not
overloaded.
3. Put the work bowl cover on top of the work bowl. Be sure the
cover is properly locked.
4. Press and hold the desired speed button.
Note: Due to the powerful motor provided with this unit,
Cuisinart recommends using one hand to support the work
bowl during operation.
5. When you have finished processing the food, stop the machine
by taking your finger off the desired speed button.
WHEN THE BLADE STOPS MOVING
6.
7. Remove the motor body with the cover from the work bowl.
, unplug the unit.
9