Flashforge Guider II Quick Start Manual page 8

Please wait while the extruder and platform
finish initial movement...
1. Tap [Tools]-[Level] on your Guider II's touch screen. Please wait while the extruder and platform
complete initial movements. Then, rotate all three knobs under the platform anticlockwise
until you can't tighten them anymore. Then tap [Ok].
Confirm
Are you sure you can't finger
tighten these three knobs any
more?
Yes
2. Tap [Yes] if you can't tighten all the nuts any more, or tap [No] to continue tightening. After
selecting [Yes], the extruder will move towards the first point and the plate will move up and
down to verify the distance between nozzle and plate.
Distance Too Big
Unscrew corresponding knob under
platform clockwise until hearing
a steady beep.
3. If the distance between the nozzle and plate is too large, rotate the knob underneath the
platform clockwise until you hear a steady beep. If the distance is too small, rotate the knob
anticlockwise until you hear a steady beep.
Please tap [Verify] button to
check whether the distance
is appropriate now.
4. Then tap the [Verify] button to check whether the distance is appropriate this time.
If the distance is appropriate now, tap [OK] to second leveling point. If still not, please follow
the prompts to adjust again till you see [OK] button.
Repeat steps 3 and 4 to level the second and third points. Then tap [Finish] to exit.
No
Wait
Verify
Screw three knobs under the platform
anticlockwise until you can't tighten them any
more, then tap [OK] button.
Verifying the distance between nozzle
and plate...
Distance Too Small
Screw corresponding knob under
platform anticlockwise until hearing
a steady beep.
Congrats
Tap [OK] button
to next point leveling.
07
OK
Wait
OK