Dahua IR High Speed Dome Camera User Manual page 58

2. Move the cursor to [AUTO-RUN] by operate the joystick upwards and
downwards, press [FOCUS+] button to enter the lower menu of [AUTO-RUN].
Move the cursor to [PATTERN SCAN], press [FOCUS+] button and show the
menu as:
3. Configure the serial number of the Pattern scan: move the cursor to
[SERIAL NO.] by operating the joystick, press [FOCUS+] button to enter the
serial number configuration interface. Press [FOCUS+] button to increase,
press [FOCUS-] button to decrease. The optional range is 001—004,
choose 001 as the present Pattern scan number, all the below operations
take this Pattern scan number as an example.
4. Recording: After the Serial Number is chosen well, move the cursor to
[RECORD], press [FOCUS+] button to enter the ―MOVE TO START POINT‖
interface. Now, you can operate the keyboard to adjust the image to the
position where the record is to begin.
5. After choosing the starting position, press 1+PREVIEW button(it means
st
invoke the 1 preset position) to begin to record, operate the IR High Speed
Dome Camera (including controlling the pan/tilt as well as the camera lens) to
move according to your desired route so that the unit can record. The
maximum recording room is 99/100 (about 4 minutes). After the recording is
finished, press 1+PREVIEW button to exit the recording operation and return
to Pattern Scan Configuration interface. Now the Cursor is pointing to
AUTO-RUN
1 PRESET POSITION
2 AUTO SCAN
3 TOUR
→4 PATTERN SCAN
IRIS+: SAVE
- 57 -
IRIS-: EXIT