Dahua IR High Speed Dome Camera User Manual page 11

7. Automatic Tours
The automatic tour function is a built-in function of the IR High-speed
Dome Camera. Through beforehand programming, the user can arrange the
preset positions into the automatic tour in the desired order. When it's needed
to run the tour, operating through the OSD menu, the user can make the IR
High-speed Dome Camera automatically move as per the order of the preset
positions configured in the tour with preset time intervals.
● The staying time at each preset position can be configured.
● Altogether 4 tours can be configured with the unit.
● Sixteen preset positions can be stored in one tour.
8. Left & right Scan
Left/right limiting positions can be conveniently set through OSD menu.
After configuring well, the user can run the left/right scan directly through the
OSD menu, then the IR High-speed Dome Camera will automatically run
horizontally between the left limiting position and the right limiting position, at
the preset speed.
9. 360° Scan
360° endless scan is supported. When running 360° scan, the unit will
rotating endlessly. There are low, medium and high 3 grades optional for the
running speed of the 360° scan.
10. Pattern Scan
The unit can store the user's operating track and invoke it when
necessary. A 4-minutes operation is acceptable to be stored for one Pattern
Scan track. Altogether 4 Pattern Scan tracks can be stored in this unit.
11. Privacy Mask
Within the monitoring range, if some privacy zones should be shielded
from being monitored, some mask zones can be set within the monitoring
image. Altogether 8 Privacy Mask zones can be set in the unit.
12. Alarm Function
The user can set the key areas as alarm points. Through the linkage with
the external-connected detector, once there is alarm signal transmitted to the
unit, the unit will promptly adjust the camera module to shoot the alarm point,
at the same time, it will output alarm signal through the alarm output port.
- 10 -